Stomp ceiling texture12/16/2023 Applying compound with a paint roller could save them some back-breaking work.įor a complete list of finishing products offered by CertainTeed, click here. In the development they are building 85 homes this year and all are hand-taped. He is a project manager for a large construction company. In fact, I was just visiting my son in the Denver area. Put a little mud into the pail and mix in a little water. 3- To texture you will need to experiment with thinning the drywall mud for the correct look. Pay attention to the edges, these to be blended with the surrounding texture. But there are still a lot of finishers who hand-tape only. 2- Apply a layer of drywall mud to the repair to help hide the area when textured. Don’t over thin or the compound will not adhere as well.Īdmittedly, the finish coat can be applied to seams using a 12-inch box (which is what I use on all my larger taping jobs). So you will occasionally have to remix with additional water and some added compound. ![]() NOTE: As you work the compound will start to dry out in the bucket because moisture is lost by continually applying and removing the material. The excess compound is just dumped back in the bucket. All you need to leave is a skim coat in most areas and where more is needed more can be left. Using a 12-inch wide knife and a mud pan remove the compound. Consider the drying conditions and apply as much compound as you can before it starts to dry.ĥ. I can usually get about 8-feet coated with each application. Apply enough pressure so that the roller turns slowly but still leaves the surface covered with compound. Now apply the compound to the seam or outside corner. Slide the bottom edge of the roller across the bucket edge to remove the dripping compound from the bottom of the roller.Ĥ. Dip it in the compound and shake of some excess if you find you are dropping too much compound.ģ. Use a 9-inch roller cover with a ½-inch or ¾-inch nap. Thin down the compound with water to about the consistency of thick pancake batter (consistency used when coating inside corners with a corner box and finishing head).Ģ. Below identifies five key steps to applying compound with a roller:ġ. In either case, it is important to apply the compound a little at a time in smaller areas, so that the compound cannot dry before it is removed.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |